Archive | camera RSS feed for this section

Customized Camera Case

5 Mar

Once upon a time I had a bright orange camera, it was protected by a cute brown and white floral Vera Bradley wallet with a little pocket for my extra battery. Then some how, magically, the camera, case, and extra battery disappeared. I searched high and I searched low, I searched in and I searched out, with no trace in sight. Time was ticking and Saturday Studios were quickly approaching so I gave up and bought a new camera, but a case was out of my budget. Here is my solution:

Supplies:

Leather scraps – or fabric scraps

Embroidery floss

A thicker gauge needle

photo 2

I traced the outline of my camera on the leather scraps, making sure to leave some room around the edges to take in consideration the thickness of the camera. The leather scraps are placed so that the faces that are touching will become the exterior of the case and what is being traced on is the interior.

photo 3

Since the leather is pretty hefty, I used large bobby pins to hold it in place while I stitched the two pieces together.

photo 4

I then used the embroidery floss to do a not-so-professional looking stitch around my template. Then I just trimmed the edges down to a little less than a quarter of an inch from the stitching.

photo 6

Once it was all stitched, I flipped the leather right side out and stretched into the corners. I tried my camera inside and it fit nice and snug, but was difficult to get in and out of. That is where the brown strip of leather comes in.

photo 7

I just made a few cross stitches at the bottom seam, top edge and stitched the ends together. This allowed for a small pull on each end of the case to help with putting the camera in and taking it out.

photo 5

Here is an image of how the top strap just moves to the side while taking the camera out or putting it in. The strap also acts as a catch in case the camera tries to slide out on its own because I assume that over time the leather will naturally stretch a bit. This project took me a little over an hour to whip up and is a simple, customizable way to protect your electronics. I am going to leave mine very plain but this project can be personalized in a million ways – different types of fabrics, paints, bleaching, size it down for a phone, size it up for a laptop!

Heather

Advertisements
%d bloggers like this: